Heat Pump Blowing Cold Air in Winter? 6 Causes and What to Do
Updated November 19, 2026 · AirMaker HVAC Inc
More and more Los Angeles homes heat with a heat pump instead of a gas furnace. When the first cold nights arrive, a common question is: “Why is my heat pump blowing cold air?” Sometimes it is completely normal. Sometimes it means a part has failed. Here is how to tell the difference.
First: heat pump air feels cooler than furnace air
A gas furnace sends air out at around 120–140°F. A heat pump usually delivers air at about 90–105°F. That is warm enough to heat the house, but it can feel cool on your hand, especially near a vent with a strong draft. If the house is reaching the temperature on the thermostat, the system is probably working correctly.
1. The heat pump is in a defrost cycle
On cold, damp nights, frost builds up on the outdoor coil. A few times an hour the heat pump switches into defrost mode for a few minutes to melt it. During defrost you may feel cooler air from the vents and see steam rising from the outdoor unit. This is normal and should stop within about 5–10 minutes.
Call for service if: the outdoor unit stays covered in thick ice, or defrost seems to run constantly.
2. Thermostat settings
- The thermostat is set to Cool or Auto instead of Heat
- The fan is set to On instead of Auto, so it blows air between heating cycles
- A smart thermostat was installed without the correct heat pump settings, so the reversing valve is controlled backwards
Check the mode and fan settings first. If a new thermostat was recently installed and the problem started right away, the wiring or configuration is the most likely cause.
3. Reversing valve problem
The reversing valve switches the heat pump between heating and cooling. If it sticks, or its solenoid coil fails, the system can stay in cooling mode even when the thermostat calls for heat. This is a repair for a licensed technician.
4. Low refrigerant from a leak
A heat pump moves heat using refrigerant. If the system has a leak, it cannot carry enough heat into the house, so the air comes out lukewarm. You may also notice long run times, ice on parts of the outdoor unit, or rising electric bills. Leaks need to be found and repaired, not just topped off.
5. Airflow problems
- A dirty or clogged filter
- Closed or blocked supply vents and return grilles
- A dirty indoor coil
- A weak or failing blower motor
Restricted airflow makes the system less effective and can trigger safety controls. Replacing the filter is the easiest first step.
6. Outdoor unit problems
Debris, leaves or a failed outdoor fan motor can stop the outdoor unit from working properly. If the outdoor fan is not spinning while the system is running, turn the system off and call for service.
What about auxiliary heat?
Many heat pumps have electric backup heat strips. If they never come on during very cold weather, the house may feel chilly. If they run all the time, electric bills go up sharply. Both point to a control, sensor or sizing problem worth checking.
What you can check safely
- Thermostat mode set to Heat, fan set to Auto
- Replace the air filter
- Open all vents and make sure returns are not blocked
- Clear leaves and debris from around the outdoor unit
- Wait 10 minutes in case it is a defrost cycle
If the air is still cold after these steps, it is time for a professional diagnostic.
Heat pump repair in Los Angeles
AirMaker HVAC Inc repairs heat pumps from all major brands across Los Angeles and the San Fernando Valley, including defrost controls, reversing valves, refrigerant leaks, fan motors and thermostats. See our heat pump services, read about heat pump noises, or keep your system ready for winter with heat pump maintenance.
Please note: This article is general information for homeowners and businesses. It is not a substitute for an inspection by a licensed technician. Costs, timelines and code requirements vary by home, equipment and city. Do not open gas, electrical or refrigerant components yourself. If you smell gas, leave the building and call your gas company from outside. If a carbon monoxide alarm sounds, get everyone outside and call 911.
Need service? Let’s fix it.
Call, text or send a request and we will get back to you during business hours.
(818) 642-527820620 Hatton Street, Winnetka, CA 91306
Monday–Friday, 9 AM–5 PM
“Vlad gave us great service. Didn’t try to sell us anything.”— Len Weed
“Vlad came out to get my heater going. He is exactly professional and knowledgeable.”— Serge S.